Measuring Guideline

Please utilize these measuring guidelines, if ordering a rack with Hookguard Shield: 

Make sure you have at least 12" clearance from the top of the gunnel to the bottom of your deck. If not, please make sure to add the extension bracket to your order as "add-on" option and provide your boat measurements in the "special instructions" section during checkout.

Please utilize these measuring guidelines if ordering a Bump Board: 

The bump board rack sits 36" in length
1. Standard Muskie Bump Board Owners/ Reck N Rack Bump Board Owners: Make sure that you have 9" clearance from the top of the gunnel to the bottom of your deck to ensure that there is enough room for the bump board to hang. If the clearance is less, we have an extension bracket that can be offered as an "add-on" option during checkout.
2. Muskie Fatboy Bump Board Owners: Make sure that you have 11" clearance from the top of your gunnel to your deck to ensure that there is enough room for the bump board  to hang. If the clearance is less, we have an extension bracket that is offered as an "add-on" option during checkout.

For ALL Rail and Traxtech System owners, please refer to the measurement requirements below: 

Rail/Traxtech Systems - A extension bracket will be REQUIRED with this setup. 

-Rail Users: 

       A. Measurement from the inside of the rail to the inside gunnel

       B. Bottom of the rail to the top of the gunnel

-Traxtech Users: Measurement from the outside track to the inside of the gunnel